[Elecraft] Configuration Questions

[Dick Dievendorff]

1) The K3 normally comes with a 2.7 kHz 5-pole filter. If you prefer a 2.8
kHz 8-pole filter instead, you can substitute it for the 2.7 5-pole by
ordering KFL3A-2.8_2.7sw at initial purchase.
2) You'll want a KXV3A for its Rx antenna connection. A KXV3A (IF out) is
also needed for the P3.
3) A P3SVGA is needed for an external monitor. It supplies an SVGA output.
See http://www.elecraft.com/P3/p3.htm#svga

73 de Dick, K6KR


-----Original Message-----
From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Richard Solomon
Sent: Wednesday, December 18, 2013 6:11 PM
To: elecraft at mailman.qth.net
Subject: [Elecraft] Configuration Questions

I am putting together my list and have some questions:

1) Does the stock K3/100 come with any filters ?

2) If I buy the Second Receiver (KRX3), do I need KXV3A ?
I do have receiving antennas for 160 & 80.

3) Can I connect an external monitor to the stock P3 or will I need an
optional VGA/DVI/HDMI port ? Which of these 3 standards do you get ?

Thanks for any help,

73 es HH, Dick, W1KSZ
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html