[Elecraft] om2500a

[Chris Pickett]

Hi Folks,
I have recently purchased the OM2500A amplifier but am confused about the
lead I need to make up 
for connection to the amplifier.
The OM Amp has a 15way D 2 row connector and the Elecraft K3 has a 15way D 3
row connector. I have the screened cable and the correct plugs etc but am
unsure of the terminology used in the two manuals as to what wires go where,
and as you can imagine, am a little worried about how to connect them.

The OM Power pin out is as follows:

1:ALC Out
2:NC
3:Inhibit Control Voltage 
4:TX Inhibit for Yaesu and Elecraft - this supersedes ALC output
5:NC
6:Key Out
7:NC
8:Key in
9:-
15:Ground

I have not listed the pin out of the K3 as I assume anyone with a common
interest will have the manual.

I would be most grateful if someone would Elmer me here because 232 coms is
simple provided the terminology used is the same. Elecraft us a whole
different list of Pin outs on their socket on the back of the K3, and I
don't want to get it wrong.

If anyone would like to help me off-list my e-mail address is
chrispickett at blueyonder.co.uk

Thanks for reading and hopefully helping,

best of 73
Chris




---
This email is free from viruses and malware because avast! Antivirus protection is active.
http://www.avast.com