[Elecraft] K2 / KPA ALC problem.

Chris Kimball mail at cvkimball.com
Wed Dec 4 07:49:29 EST 2013


I bought the K2 (SN 4913) assembled.  I don't see any special notes in the T4
section of the manual, but I'll check later today when the K2 is
disassembled.

On-the-air checks with K3CC and VE3FMC show that the signal is good at 10W
(KPA not active) and poor at 11 W (KPA on).  SSB operation AT THE SAME GAIN
SETTINGS is fine.

???
Would an impedance mismatch between the K2 and the KPA (when on) change the
ALC response?
???

Thanks,

Chris
NQ8Z



--
View this message in context: http://elecraft.365791.n2.nabble.com/K2-KPA-ALC-problem-tp7581353p7581400.html
Sent from the Elecraft mailing list archive at Nabble.com.


More information about the Elecraft mailing list