[Elecraft] anyone using iMic with K3 or KX3 and FLdigi on a PC?
Michael Babineau
mbabineau at magma.ca
Fri Aug 30 09:21:32 EDT 2013
Julie :
Make sure that FLDIGI is actually using the iMic for both RX and TX and not
the internal soundcard on the computer.
Michael VE3WMB
P.S. You might try hooking headphones or a small amplified speaker to the output jack of the
iMic to verify that you are actually getting TX audio when you are transmitting. If that seems to
be fine maybe it is a cabling problem ?
>From: "Julie Royster" <jsdroyster at bellsouth.net>
>Date: August 29, 2013 1:02:49 PM EDT
>To: <elecraft at mailman.qth.net>
>Subject: Re: [Elecraft] anyone using iMic with K3 or KX3 and FLdigi on a PC?
>Continuing my quest for PSK31 on KX3 hooked to a PC laptop, today I tried
>using RigCat instead of Hamlib in FLdigi.
>I followed the setup documented on this reflector by Dave Esquer.
>The progress is that now, if I click the tune button in FLdigi, the RF
>display on the KX3 does show some transmission BUT I cannot get any ALC bars
>to light up regardless of whether sound card levels are at 50% or 100%, KX3
>mic level is at maximum, or anything else I have tried. Per a comment in
>the blog of K4MTX, I tried reducing KX3 power a little also.
>If anyone has additional ideas I will certainly appreciate all suggestions!
>Julie KT4JR
More information about the Elecraft
mailing list