[Elecraft] K2 SSB Audio

[Don Wilhelm]

Tomy,

Remove the right side panel and dress the ribbon cable and the speaker 
cable up into the space between the top of the Control Board and the 
KPA100 - get them as far away from the KSB2 board as possible.

If that does not correct it, you may need to adjust the BFOs for the FL1 
OP1 filter.  See part 3 of my K2 Dial Calibration article on my website 
www.w3fpr.com

73,
Don W3FPR

On 8/30/2013 12:01 AM, Tomy wrote:
> Anyone ever have any problems with muffled audio on SSB with the
> K2? It seems no matter which K2 I use I keep getting reports sounding
> like a towel over the mic. I have tried various adjustments but it stays
> the same. This one I have now has that Mic kit that you can use any mic.
> I have tried the Elecraft hand mic and the Heil boom mic designed for the K2.
> Any ideas would be appreciated.
>