[Elecraft] P3 SVGA RTTY decode question

[Hisashi T Fujinaka]

Once again, I wonder if I'm being clear. THE TEXT ON THE P3 SVGA IS NOT
THE SAME AS ON THE K3. I'm not sure what the issue is.

On Tue, 27 Aug 2013, Mike K2MK wrote:

> Hi Hisashi,
>
> The P3/SVGA board is acting as a terminal. It does not do any decoding. It
> just displays the decoding done by the K3. If you're missing characters you
> may want to adjust the threshold on the K3. See the decode tips in the K3
> manual on page 33.
>
> 73,
> Mike K2MK
>
>
> Hisashi T Fujinaka wrote
>> I was copying RTTY on my P3 SVGA and I found that it was dropping a lot
>> of characters. I finally figured out how to decode directly on the K3
>> and it wasn't dropping characters at all.
>>
>> Is there something I have set up incorrectly?
>>
>> Thanks.
>> Hisashi T Fujinaka
>
>
>
>
>
> --
> View this message in context: http://elecraft.365791.n2.nabble.com/P3-SVGA-RTTY-decode-question-tp7578289p7578292.html
> Sent from the Elecraft mailing list archive at Nabble.com.
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>

-- 
Hisashi T Fujinaka - htodd at twofifty.com
BSEE(6/86) + BSChem(3/95) + BAEnglish(8/95) + MSCS(8/03) + $2.50 = latte