[Elecraft] XG3 version 1.16 firmware now available

[Paul Saffren N6HZ]

Version 1.16 of XG3 firmware is now available for general release.  Please
make sure you are using the most recent version of the XG3 utility which can
be found here for  PC
<http://www.elecraft.com/XG3/XG3_Utility_Setup_1_13_6_6.exe>    Mac
<http://www.elecraft.com/XG3/XG3UtilityOSX_1_13_6_4.zip>   or  Linux
<http://www.elecraft.com/XG3/XG3UtilityLINUX_1_13_6_4.tgz>   . 

This is a minor release which adds/fixes the following issues: 

Revision 1.16 May 28, 2013

•	A break signal is now transmitted over the serial port at the start of
frequency sweep and Morse memory playback. This appears as a 1.3 ms low to
high to low pulse on the serial TX line and can be used to trigger external
equipment. 
•	When sending a Morse string using the ‘W’ command, pressing any key or any
received serial character will now stop and exit the Morse sequence. 
•	Fixed a bug in which the first element of the first character in a Morse
string was being omitted. 

73, 

Paul (n6hz)





--
View this message in context: http://elecraft.365791.n2.nabble.com/XG3-version-1-16-firmware-now-available-tp7577887.html
Sent from the Elecraft mailing list archive at Nabble.com.