[Elecraft] K2 100 shuts down immediately - need help

[Stan AE7UT]

The transistors arrived yesterday and I did ALL Don advised.
Everything checked out and I replaced the transistors with amazing ease.
All the diodes appeared healthy and the voltage was spot on.
Start to finish and being very careful, it took about 4 hours.
I'm getting 100 watts out and all is well in Zion.

I'm still getting a "High Current" warning occasionally at the first bit of
transmission.
Is this common/normal and should I check something else?

Interestingly this is serial number #7230 but from what Don was saying it
appears to have an older amp on it.  I still haven't built a KPA100 so I'm 
not very familiar with them but it does have a shield on it as Don
described.
How important is that fix?  

Elecraft has once again endeared themselves to me.  
I have very little electronics back ground.  To be able to open a rig and
fix 
it is really cool.   This would have been unthinkable without the help of
this group.  

I want to give a special THANKS to Don W3FPR, Dale WC7S and Dick K2ZR.  

73
Stan AE7UT



--
View this message in context: http://elecraft.365791.n2.nabble.com/K2-100-shuts-down-immediately-need-help-tp7577571p7577799.html
Sent from the Elecraft mailing list archive at Nabble.com.