[Elecraft] RemoteRig with K3/0 and K3/100 No Audio on Transmit

[Brian F. Wruble]

OK, I need ideas.

I have my K3/100 with RemoteRig setup on the same bench as my K3/0 with
RemoteRig, plugged into the same router.

I have perfect control of the K3/100 using the K3/0, and received audio is
solid.

I have tried everything to get transmitted audio, and it just isn't
happening.

Here is the setup:

I am using a Heil ProSet Elite. * I have JMP1 removed from the control
RemoteRig ("RR")*

I have the K3/100 set for rear panel.  For the mike menu options,  I have
tried "HigH, and "Low", and Bias on and Bias off.  Nothing makes any
difference.  Of course, I have selected the rear mike jack in each case.

I have tried setting the Radio Settings on the RRs to Dual "yes" and Dual
"No"

I have tried several different "audio quality" settings, included the one
recommended in the K3/0 manual, and I always have them set up to match
between the remote and the control RR.

I have perfect CW operation, but I get a correct (locally generated)
sidetone in the right earphone, and a not-accurate (lots of dahs) sidetone
in the left earphone.

Another mystery --- when I power down on the control (K3/0) device, the
remote (K3/100) XMIT light goes on briefly as it powers down.  Perhaps that
is a clue.

Can anyone suggest a process I might try that will get me up and running?

Tnx.

73 de Brian W3BW


*Brian F. Wruble, C.F.A.

*70 is the new 40.*
*
Mail: 1107 Key Plaza, PMB 447 Key West, FL 33040-4077
Summers: P.O.Box 57, 7400 Augustine Herman Highway, Georgetown, MD 21930
eFax  305.768.0278