[Elecraft] KX3 Utility Firmware load status question

[Phil Hystad]

On the KX3 utility program (I use the Mac version) the Firmware page shows the version numbers of the firmware loaded on the KX3 as well as the firmware available for the KX3 (the two columns).  But, for the loaded firmware, only the version number for MCU is shown, the other version numbers are indicated N/A.  Now, for each of these N/A entries, there is a corresponding entry in the "available" (next column to right) with the actual version number.

Why does the KX3 not show the version number loaded (installed) on the KX3 for these others (other than MCU)?

Similarly, I have noticed this on other utility programs too and I am not sure why some say N/A and others give the version number.

73, phil, K7PEH