[Elecraft] calibrating the KPA3

[Dave Packard]

I'm slow, but I'm getting there with K3 kit #05642.  I installed the 
KPA3 PA and I'm doing the calibration with the latest version of the K3 
Utility software.  All went well with the 5 watt calibrations, but I 
noticed that the calibration failed at 50 watts.  I'm still in the 
utility program and it now wants to test at 1mw for the transverter 
output.  I do have the K144XV 2m transverter and plan to install it 
after the KRX3 subreceiver. So, do I have the transverter output 
connector referred to by the utility program?  Should I perform the 
transverter calibration following K144XV installation?

     Many thanks, Dave K1YHR.