[Elecraft] K2 problem RX

[Don Wilhelm]

Christophe,

What you observe is normal if your sidetone pitch setting is 700 Hz.

When using CW mode, the K2 transmit frequency will be offset from the 
receive frequency by the amount of the sidetone pitch setting you have 
in the menu.  If you are in CW normal, transmit will be lower, in CW 
reverse, it will be higher.

There is no offset for SSB or RTTY modes - the transmitted carrier 
(suppressed) frequency will be the same as the receive carrier frequency.

If you need assistance calibrating the K2 dial frequency, read the K2 
Dial Calibration article on my website www.w3fpr.com.

73,
Don W3FPR

On 4/30/2013 8:38 AM, Christophe F8ACF-56 wrote:
> Hello list,
>
> I want to know if I have a problem with my K2?
>
> listening to the tag "DK0WCY" it is on 10.144, off if I listen with the display of 10,144 in "CW" is OK, if I put the filter "CW FL1" I have to flunk my reception lower than 700 hz so: 10.143.3 MHz normal?
>
> I stalled the display as described in the manual listening WWW 10 mhz, the whole procedure is well spend.
>
> I hear both the beacon on 14.100 in "CW" and even if I put the problem FL1 and other
>
> K2 is OK to transmission anything I already reported some contacts what fun!
>
>    I still KAF2 under construction and KNB2, KSB2, KPA100 build
>
> thank you for your help
>
>