[Elecraft] OT: APP strain relief

[ab2tc]

Hi all,

I have recently converted more or less completely to Anderson Power Poles
for all my power supply needs. I use an 8-way "hub" from Powerwerx as my
"distribution center". No fuses as the switching power supplies are current
limited and probably failsafe in the event of most electrical component
failures. For the big stuff, radios with #12 power wires I am not  worried
about the lack of strain relief on the connectors. But for the flimsy power
cables supplied with accessories like my KAT500, LP-100A, Lantronix serial
servers I am. Has anybody found a good solution for this? Should I just fill
the back of the connectors with epoxy or is there a better way?

Knut - AB2TC



--
View this message in context: http://elecraft.365791.n2.nabble.com/OT-APP-strain-relief-tp7573006.html
Sent from the Elecraft mailing list archive at Nabble.com.