[Elecraft] K3 stuck in transmit?

[Don Wilhelm]

Ross,

If you have everything disconnected from the K3 except power and a dummy 
load, then I have no really good ideas of the cause.
Are you certain it is in Transmit?  Is there any power output developed?

If it is really in transmit and power out is developed, I would suggest 
trying an EEINIT - hopefully you have a saved configuration file so you 
don't have to do all the re-calibration process manually.  See the 
manual section on Parameter Initialization for the steps involved.

73,
Don W3FPR

On 4/19/2013 7:14 PM, Ross Primrose wrote:
> My K3 is stuck in transmit. As soon as it powers on, it goes straight 
> into transmit. Nothing I've tried has corrected the problem. At this 
> point, there's nothing connected to the K3 except power and a dummy 
> load, still can't get it out of transmit. Doesn't want to respond to 
> the serial port (when it's hooked up, of course) either.
>
> Ideas?
>
> 73, Ross N4RP
>