[Elecraft] Mounting/cabling PR6

[Mike K2MK]

Hi Jim,

The small black connector that fits into the PR6 is a really tight friction
fit. I doubt it could be accidentally pulled out. 

The red and black wires terminate in a RCA plug that goes into the back of
the K3. It's no more likely to pull out then any other K3 rear cable. (If
you also have a P3 you would need a RCA "Y" cable).

The white wire is more problematic. I extended mine and have it wired into a
15 pin fanout board for the K3 accessory socket.

73,
Mike K2MK


Jim AB3CV wrote
> The little 3 pin connector without any strain relief and wires hanging off
> it give me concern.
> 
> How have others made this connection secure mechanically?
> 
> I'm thinking of making up a little block with a phono plug for the control
> signal and a power pole for power and somehow securing this to the PR6
> case, perhaps with double sided foam tap.
> 
> I'll make up some RG8X BNC/BNC jumpers for the ins and outs.
> 
> Pix and links wanted.
> 
> Thanks
> 
> jim ab3cv





--
View this message in context: http://elecraft.365791.n2.nabble.com/Mounting-cabling-PR6-tp7572806p7572807.html
Sent from the Elecraft mailing list archive at Nabble.com.