[Elecraft] K3 power supply recommendations

[Joe Subich, W4TV]

Depends on the version ... some pots are mounted vertically,
some flat, some have holes in the board to adjust through, etc.

My preference is the RS-35A ... the non-metered version.  I find the
metering not that accurate.  Since the supplies are mounted below
the bench and I usually get the DVM when setting them up, I don't
see a justification for the added expense <G>.

73,

    ... Joe, W4TV


On 4/16/2013 10:37 AM, Richard Fjeld wrote:
> I haven't pulled the cover on my RS-35M yet.  Does it have adequate clearance to get to the pot, or did you have to improvise?
>
> Rich, n0ce
>
>    ----- Original Message -----
>    From: Mike Reublin
>    To: Tom Branton
>    Cc: elecraft at mailman.qth.net
>    Sent: Tuesday, April 16, 2013 9:05 AM
>    Subject: Re: [Elecraft] K3 power supply recommendations
>
>
>    I've used an Astron RS-35M very happily for years. Had to turn it up a tad for the K3.
>
>    Tip: The voltage adjustment is on the under side of the board......
>
>    73, Mike NF4L
>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>