[Elecraft] IS command...only for main receiver? What about sub?

[Joe Subich, W4TV]

*WRONG!*  I use it in my mode specific set-up macros in DXKeeper
(WinWarbler) to reset the sub RX filters when switching among Phone
(IS 1400;), DATA A (IS 9000;), FSK D (IS 9000;) and CW (IS 9000;).
If I fail to include the IS command, the sub RX filters are not
centered when switching from Phone to CW/DATA A/FSK D because the
BW command leaves the center frequency unchanged.

I do not use diversity in those modes - I regularly use dual RX.

73,

    ... Joe, W4TV


On 4/10/2013 8:56 PM, tomb18 wrote:
> Nope. only in diversity.  Otherwise IS only sets the main receiver.  If you
> go into bset it doesn't change it and if you then give a IS; it only reports
> a question mark.  IS never changes the sub receiver shift except in
> diversity.
>
>
>
>
>
>
>
> --
> View this message in context: http://elecraft.365791.n2.nabble.com/IS-command-only-for-main-receiver-What-about-sub-tp7572463p7572471.html
> Sent from the Elecraft mailing list archive at Nabble.com.
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>