[Elecraft] K3 - Filter suggestions for new builder

[Adrian]

That's right Bruce, Everyone to their own. I like the 2.8k filter too, and
did try the 2.7k filter which you get mandatory in any case. I just
preferred the difference I could hear in the tx/rx audio (tx sent back me
recorded on test).

I use both the 2.1k & 1.8k and would not give up either. Also use 250hz > cw
& rtty.

If I could use that 13k for AM without a config change it would be perfect,
I was hoping Wayne was serious when he asked Joe to be the guinea pg.

-----Original Message-----
From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Bruce Beford
Sent: Wednesday, 26 September 2012 6:13 AM
To: elecraft at mailman.qth.net
Subject: Re: [Elecraft] K3 - Filter suggestions for new builder

I would not assume "most" users prefer this. I have 2.8/1.8 and it suits me
just fine, thank you. The 1.8 works well under contest conditions, when
needed. Remember there is almost always a silent majority.
 
73,
Bruce, N1RX
 
> Interesting that most here have gone with the 2.1 vs. the 1.8 KHz filters.

 

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html