[Elecraft] KAT2 high SWR problem..?

[Mike K8CN]

Gil,

When you say you completed your KAT2 build, did you complete all of the
final calibration steps, specifically the bridge null adjustment (p. 16 of
the KAT2 manual) and the power calibration adjustment (p. 17)?  I would be
surprised if you could make those adjustments successfully and yet have the
low output power you indicated into a good 50 ohm dummy load - a problem
with T1 connections would be revealed during one or both of those
adjustments if that were the source of difficulty.  Be sure that you also
have selected on the K2 front panel the correct antenna port (Ant 1/2)  to
which your dummy load is attached.

73,
Mike, K8CN



--
View this message in context: http://elecraft.365791.n2.nabble.com/KAT2-high-SWR-problem-tp7563004p7563023.html
Sent from the Elecraft mailing list archive at Nabble.com.