[Elecraft] K3 Software

[Todd - k1tm]

Have you looked at DX Labs Commander?  The macro capabilities let you adjust
pretty much anything that can be set in the K3 via software control.  You
need to do the customization by developing the macro's, but the end results
are very good.  I run the K3/P3 completely from the keyboard and the mouse. 
The mouse wheel dials the frequency up and down.  Fkeys are set for frequent
operations, and sliders and soft buttons do the rest.  Each macro can have
up to 32 steps.  The only bug I have found is that the NR settings won't
change using the UPB and DNB commands, but that is a K3 known bug.  

73, Todd



--
View this message in context: http://elecraft.365791.n2.nabble.com/K3-Software-tp7562908p7562945.html
Sent from the Elecraft mailing list archive at Nabble.com.