[Elecraft] [PSSVGA] Betta software messed up the K3

[Igor Kosvin]

After installing P3 SVGA module everything was fine. Then  I decided to try
the beta software for P3. I had trouble loading it, the P3 utility would
show that one of the FPGA images will not load. After couple attempts
suddenly MCU LD appeared on K3 display and the red TX LED on K3 would blink.
No matter what I do the K3 is stuck in this state and P3 is not working
either. When I try loading the software again to P3 it only downloads the
MCU and do not recognize the SVGA at all. What did I do wrong and how can I
correct the situation? Did anybody have similar problem?

 

Thanks,

 

Igor, N1YX