[Elecraft] KXFL3 Calibration Procedure - Signal generator question

[iw7dmh]

Good morning,

I am wondering if the calibration procedure, reported on pag. 4 of KXFL3
manual rev A2, can be executed using RigExpert AA-54 embedded signal
generator.
As stated in AA-54 manual, signal has rectangular waveform and a level of
about +13 dBm (at the 50 Ohm load).
On the other side, in KXFL3 manual, the required signal should have a level
between approximately -73 and -33 dBm.
Could this level difference damage filter board or cause other kinds of
troubles?

Thank you.

73', de Enzo
IW7DMH



--
View this message in context: http://elecraft.365791.n2.nabble.com/KXFL3-Calibration-Procedure-Signal-generator-question-tp7562476.html
Sent from the Elecraft mailing list archive at Nabble.com.