[Elecraft] Vedr: [KX3] Does the KX3 support the Kenwood Master/Slave connection?

[Wayne Burdick]

AI1 and AI2 modes are extremely slow, not suited to rig control in my  
opinion.

For the KX3 we've created a new protocol, AI4, which is much faster  
(although not as fast or comprehensive as the K3-to-K3 protocol). In  
addition to using the menu entry, you can put a KX3 into "terminal"  
mode by sending it an "AI4;" command. Once the KX3 is in this mode, it  
sends control activations to a remote KX3, K3, or K2 immediately, and  
is *almost* like being there :)

73,
Wayne
N6KR


On Sep 10, 2012, at 8:32 AM, Holger Schurig wrote:

> A post note:
>
> I didn't yet use that menu entry, but I played a bit with the AI1; and
> AI2; serial commands, which I think are similar.
>
> 73
> Holger, DH3HS