[Elecraft] Location, location

[N2TK, Tony]

Mike,
I have had each of my K3's tight up against the 2000A, 91B and 87A
(transformer side)without any issues. But I must say at one point I had a
cockpit error when I upgraded the firmware. For some reason the Line-In was
at maximum. I was getting hum on my transmit audio if I was closer than a
several inches from a transformer. Used a piece of steel as a shield that
helped till I figured out what was going on. Reduced the Line-In and
everything has been fine since. Duh!

73,
N2TK, Tony

-----Original Message-----
From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Mike Harris
Sent: Thursday, September 06, 2012 5:06 PM
To: elecraft at mailman.qth.net
Subject: [Elecraft] Location, location

G'day,

Might be having to reconfigure the equipment layout.  Anyone with experience
of running an Acom 1000 or similar chunky linear with the transformer side
only about 1 foot away from the left hand side of a K3. 
  That is right hand side of Acom to left hand side of K3.  The gap is
currently approximately two feet with no apparent ill effect.

Regards,

Mike VP8NO




______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html