[Elecraft] P3 SVGA Tx/Rx Window Sizes

[Paul Saffren N6HZ]

Hi Tom, 

There are several factors that control the number of Rx and Tx window line
counts.  The resolution of the display, the height of the waterfall and the
font size are the most important settings.   Obviously if you're trying to
use a large font (fntD=3) and a low resolution (1024x768) with the waterfall
height set low, you're going to be limited to the number of lines that can
be displayed.   Try increasing the height of the waterfall and/or reducing
the data font size.   

The current BETA firmware is available  
ftp://ftp.elecraft.com/P3/firmware/beta/P3SVGA_119BETA.zip here 

73, 

Paul


W0ZR wrote
> 
> 
> 
> 
> The window sizes on the screen on my P3 SVGA only go from 2-5 on WinR and
> from 0-3 on WinT when setting up for RTTY.  The manual says the window
> sizes should go up to "40" lines total.  I have the data font size set to
> the smallest font.
> 
> Tom, W0ZR
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at .qth
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> 



--
View this message in context: http://elecraft.365791.n2.nabble.com/P3-SVGA-Tx-Rx-Window-Sizes-tp7562075p7562140.html
Sent from the Elecraft mailing list archive at Nabble.com.