[Elecraft] [KXUSB]

[Dick Dievendorff]

The KUSB has a USB connector on one end and a 9-pin D-shell connector on the
other end. It's for the K3 and KPA500 that have 9-pin D shell RS-232
connections.

The KXUSB has a USB connector on one end and a molded right-angle 3.5mm TRS
(tip, ring, shell) plug on the other.

The KXSER has a 9-pin D-shell connector on one end and a molded right-angle
3.5mm TRS plug on the other.

The 3.5mm TRS connector for RS-232 communications is used with the W1, W2,
K144XV, XG3, KX3, and KAT500.

73 de Dick, K6KR


-----Original Message-----
From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Donald Thompson
Sent: Monday, September 03, 2012 2:47 PM
To: Elecraft Reflector
Subject: [Elecraft] [KXUSB]

I have been swapping my serial USB adapter between my K3 and other uses and
its becoming a pain.   I need to get a second USB Serial Adapter and was
about to order the KUSB with FTDI chip listed under the K3 options on order
page.  I was also going to order the XG3 RF Signal Source and noticed it
comes with a KXUSB.  I don't see a KXUSB listed elsewhere.  Is this the same
as the KUSB?
73
Don 
KA1KU

Sent from my iPhone
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html