[Elecraft] K3--Digital Mode Question (New Tricks...Old Dog)

[Bruce Beford]

> From what I could tell from the manual,
> Line Out to my PC ought to be a level adjusted by Config: Line Out.
> However, each time I turned down the AF control, the signal to FLdigi
> went away.

Dick, from the menu parameter section of the manual: (see second paragraph.
Try tapping "1" while in the menu, at the LIN OUT parameter).

LIN OUT: (NOR 010) Sets the LINE OUT level. LINE OUT connections go to PC
soundcard inputs. Settings above 10 may result in overdrive of the soundcard
or saturation of the KIO3's isolation transformers; monitor signals using
the PC to avoid this.

Note: Normally, LIN OUT sets a fixed-level receive-only output for main/sub
(L/R), compatible with digital modes. Tapping 1 switches LIN OUT to
=PHONES, where the line outputs match headphone audio, audio level is
controlled by AF/SUB gain controls, and both RX and TX audio are available.

GL,
Bruce, N1RX