[Elecraft] Audio line out for digital modes

[Don Wilhelm]

Chris,

I am going to assume a K2, but you did not state which transceiver you have.

Take a look at the K2 Fixed Audio Output article on my website 
www.w3fpr.com.  Boards are no longer available, but the circuit is 
simple enough to build on a piece of perfboard.
You should also look at the updated design shown on Tom Hammond's (SK) 
website www.n0ss.net.  If you lay all the components flat on the board, 
it will fit nicely between the front panel and the control board.

73,
Don W3FPR

On 10/29/2012 7:58 AM, Chris Kimball wrote:
> I'm considering going to digital modes with the SignalLink USB gizmo.
>
> Connecting via the headphone out or speaker out will kill the speaker audio.
> I'd like to add an audio line out, not necessarily gain-controlled, but
> capable of operating into the SignalLink's 600 ohm impedance. Might bring
> out through the disused external speaker jack.
>
> Any suggestions before I take on the ol' 100 W iron?
>
> Chris
> NQ8Z
>
>
>
> --
> View this message in context: http://elecraft.365791.n2.nabble.com/Audio-line-out-for-digital-modes-tp7564746.html
> Sent from the Elecraft mailing list archive at Nabble.com.
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>