[Elecraft] K3 Receive Sensitivity Consistency

[David Little]

Preamp, Attenuator, ATU, AGC were all checked before determining that the
audio on 60m was lacking.

The levels on the P3 were also checked to aid in determining the problem.  

RX EQ was all maxed out in able to overcome the inherit audio attenuation
when the EQ settings are moved off of +16.

My guess is that it seems to be firmware related, and for now, the problem
has been cleared out of the processors scratch pad memory, and may not show
up again.........

Thanks,

David
KD4NUE


-----Original Message-----
From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Dale Boresz
Sent: Sunday, October 28, 2012 2:11 PM
To: elecraft at mailman.qth.net
Subject: Re: [Elecraft] K3 Receive Sensitivity Consistency


David,

Check your PRE and ATT setting on 60m compared to your other bands. I 
would guess that you have the ATT engaged on 60m and not on the other bands.

73, Dale
WA8SRA