[Elecraft] Info 080 message started with RF Alignment and Test, Part II

[AC8HU]

Ok that's what I'd thought about the resistance value there - the note (on
Info 080 troubleshooting, in builder resources) had said that the resistors
should be 470 ohm, and that the range should be 900-1000 ohm.  However all
through the manual those resistors are referred to as 100 ohm, which is what
I have installed at those points, and my measured resistance value of around
198 ohm would be just about dead on.  So no concern there.

Just have to figure out what my VFO knob problem is now - checked solder
points on the small optical encoder board and then gave it another shot, and
it's still not working.  Just as before with the sudden appearance of the
Info 080 message, there's probably one solder point somewhere that's flaky
and it's causing my problem.



--
View this message in context: http://elecraft.365791.n2.nabble.com/Info-080-message-started-with-RF-Alignment-and-Test-Part-II-tp7564545p7564638.html
Sent from the Elecraft mailing list archive at Nabble.com.