[Elecraft] K2 Question

[Christophe F8ACF-56]

hello list,

Thank you again now it is more clear to me.

 
73 , Christophe F8ACF-56


________________________________
 De : Don Wilhelm <w3fpr at embarqmail.com>
À : Christophe F8ACF-56 <f8acf56 at yahoo.fr> 
Cc : "elecraft at mailman.qth.net" <elecraft at mailman.qth.net> 
Envoyé le : Lundi 22 octobre 2012 15h33
Objet : Re: [Elecraft] K2  Question
 
Christophe,
That header is to select the input to the internal K2 voltmeter.  If you 
are using that sincle wire probe that the manual instructs you to build, 
you will put the jumper on the two pins marked "EXT", but normally you 
will place it on the pins marked "INT"

Note, if you have th ejumper on EXT and do not connect a voltage to the 
probe, you will see an occasional "LO BAT" display flashed.

73,
Don W3FPR

On 10/22/2012 6:26 AM, Christophe F8ACF-56 wrote:
> hello all,
>
> control board on K2, there "P7" he must put the rider in a unique position to test or not to wear?
>
> there is nothing to indicate on this jumper, so I would ask.
>
> during assembly
>
> K2 # 7369
>