[Elecraft] Resistor networks, polarized?

[Vic K2VCO]

If you reversed RP1, 2 or 3 then you are OK. But RP5 has one side of all the resistors 
connected together and to pin 1! Look at the schematic and you'll see this. There doesn't 
seem to be a RP4.

One way to remove it is to cut all the pins with flush cutters and then take them out one 
at a time. You will need a new part, but it's better than damaging the board!

On 10/18/2012 4:35 PM, Gil G. wrote:
> Hello,
>
> I am building the KSB2 tonight, and I put a resistor network the wrong way..
> Aren't these just resistors? Why would there be a pin 1? Should I remove it?
> If so, how do I do that? I have solder wick, tried, but it isn't budging…
>
> Thanks,
>
> Gil.
> --
> PGP Key: http://keskydee.com/gil.asc
>

-- 
Vic, K2VCO
Fresno CA
http://www.qsl.net/k2vco/