[Elecraft] KX3 Question

[Mike Harris]

In the past, instead of transcribing the content of the errata into the 
main manual I have simple added a note at the appropriate place "see 
errata #1" and so on.  Saves a lot of writing.

Regards,

Mike VP8NO

On 14/10/2012 14:04, Phil Hystad wrote:
> Joel,
>
> Thanks for the clarifying comment below.  I remember reading the errata and
> marking up my documents with changes but I totally briefed over the part
> about the change to calibration (you noted below) and then forgot about it.
>
> This was done in the rush to process all the errata sheets to get required
> changes written into the manuals and my main focus at the time were
> changes to installation and assembly, not to other stuff.  Oh, well, my
> fault for doing this late on Wednesday night when I should have been
> in bed asleep.
>
> 73, phil, K7PEH