[Elecraft] Am I the only one not getting the KX3 trans bias cal test???

[Mike Weir]

I was just wondering if I am the only one having troubles with one of the cal tests....namely the Transmit bias test. It is just not working for me. I posted on this site, Elecraft's nabble and even sent an email to Elecraft. All post have netted no comments at all. In the past I have had great response to questions this time nothing. Well going to try again below is the problem I am having. 
I was attempting to run the transmit bias test and all that is happening is both for CW and SSB when I press XMIT on the LCD I get a reading of .04A ranging up to .09A  and Q6 below that. The instructions say this test is to take between 3-10 sec my test was into 1.5 minutes. The LCD just continued to role between .04A and .09A. I tried SSB and the same thing happend just the numbers were from .08A-.18A again with Q6 below the reading. I was not getting an error message and there was nothing on the BNC connector and I did unlock the TX Bias menu.
Mike
VE3WDM