[Elecraft] KX3 transmit Bias test

[Mike Weir]

I was attempting to run the transmit bias test and all that is happening is both for CW and SSB when I press XMIT on the LCD I get a reading of .04A ranging up to .09A  and Q6 below that. The instructions say this test is to take between 3-10 sec my test was into 1.5 minutes. The LCD just continued to role between .04A and .09A. I tried SSB and the same thing happend just the numbers were from .08A-.18A again with Q6 below the reading. I was not getting an error message and there was nothing on the BNC connector and I did unlock the TX Bias menu. 
Mike
VE3WDM