[Elecraft] P3/SVGA firmware Version question

[T Gahagan]

I’m a bit confused about P3 firmware.  I saw mentioned in past posts that a beta P3 version 1.18 was available.  When I direct the P3 utility to the Elecraft “Mother ship” it says that P3 version 1.20 is available.  Upon downloading and installing 1.20 the P3 utility no longer sees my SVGA board.  Restarting the P3 utilitiy does not help.  It says the SVGA board is not available.  If I load the Beta version?? 1.18 and refresh the utility the SVGA board appears again.  When I update the SVGA firmware it gives me an error code stating that it was unable to do a reset after firmware was downloaded but if I shut the P3 off and then turn it back on it shows that the firmware download was successful.  I know I must be doing something wrong or am missing something but not sure what it is.  Hopefully someone on the reflector can shed some light on my confusion.  

Thanks,
Todd, WA7U