[Elecraft] K3 : ERR TXG on 50W TX Gain Calibration routine...

[zendoc at netspace.net.au]

Hi Group,

I've just re-run the TX Gain calibration routine on my K3 using the K3
Utility 1.12.9.22 and hit a snag.

5W and 1mW calibration routines run perfectly, all bands.

On the 50W calibration, on the 50Mhz band, the K3 LCD display show the
ERR TXG message.  All other bands calibrate without error at 50W.

The K3 Utility reports no error - it confirms in its last message that
the 50W calibration routine has completed successfully.

So do I believe the K3 LCD ERR TXG message,  or the K3 Utility's
"success message"?

Where do I look now?

I've run this routine several times before without any reported errors

Thanks for any advice,

73,
John
VK7JB