[Elecraft] Display frequency calibration

[Jack Berry]

No, I'm set flat in rx eq. Was easy to zero beat using 20mHz WWV and the procedure. 

Thanks!

On Oct 5, 2012, at 10:44 AM, Eric Swartz  WA6HHQ - Elecraft <eric at elecraft.com> wrote:

> Is your RX EQ set to roll off lower freqs? The 1-5 Hz zero beat note is easily heard when listening to the WWV carrier beating against the CW spot tone on the K3.
> 
> Eric
> 
> www.elecraft.com
> _..._
> 
> 
> 
> On Oct 4, 2012, at 9:46 PM, K7WIA <emoss98133 at msn.com> wrote:
> 
>> Just another note:    My K3 will not produce a audio tone below 200 cycles in
>> the speaker.. ( could be my ears) so finding a zero beat is impossible as I
>> could be off that much above or below WWV trying to callibrate that way.....
>> 
>> 
>> 
>> --
>> View this message in context: http://elecraft.365791.n2.nabble.com/Display-frequency-calibration-tp7563715p7563723.html
>> Sent from the Elecraft mailing list archive at Nabble.com.
>> ______________________________________________________________
>> Elecraft mailing list
>> Home: http://mailman.qth.net/mailman/listinfo/elecraft
>> Help: http://mailman.qth.net/mmfaq.htm
>> Post: mailto:Elecraft at mailman.qth.net
>> 
>> This list hosted by: http://www.qsl.net
>> Please help support this email list: http://www.qsl.net/donate.html
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html