[Elecraft] KEY OUT and TX Delay

[WL7M]

I have a Ten Tec Hercules II amp I'm not using and I was thinking about
trying it with my KX3. 

I know the KX3 has a KEY OUT available on the ACC2 jack (I did purchase the
ACC2 Module).  From what I've read, Ten Tec amps will work with a non-Ten
Tec transceiver without the full keying loop if there is a short delay (4-8
msec?) between the transceiver's KEY OUT closure and the application of RF.

My question: Is there any delay built into the KX3 between KEY OUT closure
and transmitting RF?  

I've read about the 8 msec+ adjustable TX Delay for the K3 but couldn't find
any references to TX Delay and the KX3. I know there's a CW Delay setting in
the KX3 menu, but that controls the time it takes the KX3 to switch back to
receive after key-up.

I'm not hoping for full QSK, but slow QSK/semi-break in would be nice.

Thanks,
John Pfeifer
WL7M



--
View this message in context: http://elecraft.365791.n2.nabble.com/KEY-OUT-and-TX-Delay-tp7566303.html
Sent from the Elecraft mailing list archive at Nabble.com.