[Elecraft] K3 Problems

[Bruce Beford]

This sounds like the issue that has been occasionally seen where one of the
rotary encoder push buttons fails in the "on" state. Another possibility is
a failure of a button mux/demux circuit. In either case, a front panel board
swap-out may be the next step. Hopefully, you will hear back shortly from
Elecraft support on the next logical step to troubleshoot.
Good luck,
Bruce, N1RX
 
> Thank you Don, but you need to read my latest reply to Gary.
> The SHIFT LO NORM button is not working correctly - so what you are both 
> suggesting will not work.