[Elecraft] k2 encoder dial

[Jim Wiley]

Make sure the "dial lock" function is not engaged. If it is, the decimal 
point to the right of the 1 kHz digit will be flashing.  If that  is not 
the case, then perhaps the encoder is not wired correctly, or there is a 
solder splash or something similar.

Try direct frequency entry.  To do this, press BAND+ and BAND- 
simultaneously, release them, and use the 0-9 buttons for direct entry. 
use 4 digits for 80, 60  and 40 meters, 5 digits for 30 meters and 
higher,  leading 0 plus 4 digits for 160 meters.


- Jim, KL7CC


On 11/23/2012 2:32 PM, haircutter at verizon.net wrote:
> Finally recieved my missing parts for the control board and fired up the K2
> for the first test. All
> the relays, switches etc. work fb. But I can't change freqs when I turn the
> main dial. The rit works  ok
> No error messages. Guess I will have to take the front board out and recheck
> everything..
>
>
> Don....w2xb
>
>
>
> --
> View this message in context: http://elecraft.365791.n2.nabble.com/k2-encoder-dial-tp7566137.html
> Sent from the Elecraft mailing list archive at Nabble.com.
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>