[Elecraft] KX3 and digital modes

[Edward R Cole]

I would think anyone with an XG3 could use to do the extended VFO 
calibration.  I tested mine and it has reasonable accuracy and 
stability.  Of course I have a mw counter with E-11 accuracy for 
checking this so I can just set the KX3 exactly to that frequency.

I have not run the KX3 thru frequency measurements so may have to do 
that after trying the procedure recommended by Wayne.  I run the KX3 
on 28-MHz IF for 2m-FM so that mode is a good test of frequency 
drift.  I run the KX3 at 3w to drive my 2m-transverter.

When I have made these tests I will add the results to the 
power-point review I made for the proceedings of MUD-2012.  It is on 
my website in pdf form:
http://www.kl7uw.com/Review_of_Elecraft_KX3.pdf

73, Ed - KL7UW