[Elecraft] K3 Utility Reload issues

[Dick Dievendorff]

Please carefully go through the steps listed in K3 Utility Help,
Troubleshooting, MCU Load Failure.

If you are using a different COM port than you were using before, be careful
that you've selected the correct new COM port

73 de Dick, K6KR

-----Original Message-----
From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Roger Huntley
Sent: Tuesday, November 20, 2012 9:43 PM
To: elecraft at mailman.qth.net
Cc: 'Bob Sampson'; 'Chuck Jones'
Subject: [Elecraft] K3 Utility Reload issues

I tried to download latest K3 utility version 1.12.10.10 and ended up with
dead radio.  I tried the help advise and their recommendations ending with
still  nothing working.  I disconnected MicroHAM  keyer and the power  to
K3, connected radio direct to computer with  RS 232 outlet direct to COM
port, turned power off to radio, reapplied power and tried to reload
software and still only flashing TX LED with MCU LD showing without back lit
screen.  Any suggestion appreciated.
Roger, W7VV


______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html