[Elecraft] kat 500 programmers manual error?

[Dick Dievendorff]

Hi, Brian!

It's neither a true change nor a doc error.

The KAT500 BN uses the BN number convention from the K3 programmer's
reference.

See the K3 Programmer's Reference, BN command.  

The BN command values (for both K3 and KAT500) differ from the numbers you'd
expect from the BAND0 to BAND3 lines on the K3 back panel ACC connector.

73 de Dick, K6KR

-----Original Message-----
From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net] On Behalf Of briana
Sent: Wednesday, November 21, 2012 5:40 AM
To: elecraft at mailman.qth.net
Subject: [Elecraft] kat 500 programmers manual error?

I notice in the table for band commands, that it is shifted one from
standard K3 bito, bit1, bit2, bit3 values.

For example 160 M is a zero in the KAT500 command while it is a 1 for
standard band data.

Is this a true change or a doc error?  I don't have a KAT500 to test it out.

73
Brian/K3KO
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html