[Elecraft] K3 no mod from FP conn

[Guy Olinger K2AV]

You have not yet mentioned tapping "2" with MAIN:MIC SEL on to toggle the
bias.  The bias for FP.x  and the bias for rP.x are independent and set by
tapping "2" when you have either of them selected.

The bias on the front pin should toggle on and off with the menu display
going back and forth between "FP.x bIAS" and "FP.x      " .

Does it not do this?

73, Guy.

On Fri, Nov 16, 2012 at 1:17 PM, Jan Erik Holm <sm2ekm at bdtv.se> wrote:

> Yes MIC BTN....understand, it´s off anyway.
>
> MIC SEL....yes I know.
>
> I was looking in all menus for the bias since I was
> thinking that it was the culprit but didn´t find it.
> However since it works from the rear panel connector
> and not the FP connector can it still be the bias?
>
> /Jim
> -------
> On 2012-11-16 17:52, Don Wilhelm wrote:
> > Jim,
> >
> > The MIC SEL menu item is found in the main menu.  The entry in the
> > CONFIG menu is MIC BTN which is for the :MIC BUTTONS - that is the up
> > and down buttons if they are present.
> >
> > 73,
> > Don W3FPR
> >
> > On 11/16/2012 11:11 AM, Jan Erik Holm wrote:
> >> OK Guy,
> >>
> >> Well if it works from the rear bias must be off....or???
> >>
> >> I have in CONFIG "mic bnd" off ( I think it was).
> >>
> >> But will try this tapping "2"
> >>
> >> /Jim
> >>
> >
> >
>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>