[Elecraft] K3: How to setup K3 with Signalink-USB ?

[Jeff Herr]

During system boot as the various drivers load they will assert i/o as they
initialize the hardware they "own".
Com port pins might toggle, video memory get initialized, drives might be
"homed", etc.

Normal stuff




-----Original Message-----
From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Mike Harris
Sent: Thursday, November 15, 2012 04:09
To: elecraft at mailman.qth.net
Subject: Re: [Elecraft] K3: How to setup K3 with Signalink-USB ?

My Dell Win7/64 box keys the K3 seven times in a burst on boot up.  If the
K3 is already on I just enable TX test until boot up has completed.

Regards,

Mike VP8NO

On 15/11/2012 08:53, KD7YZ Bob wrote:
> Howdy K3' people:
>
> I have another 'Newbie User' Question.
>
> This one regards the fact that I notice when the K3 is already on AND 
> I then turn-on the Windows-7 machine, at some point the rig switches 
> to Xmit. Per the manual, it goes into "Test" mode, and thus, no RF Power.
>
> No other "Radio" software programs had been "Started" yet.
>
> K3 associated with COM1 which is 38400-8N1/Xon/Xoff
> K3 Baud Rate to 38400
>
> This,  for me anyway, repeatable.
>
> While not a problem OF the K3, whatever I haven't set up is annoying.
>
>
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html