[Elecraft] KX3 CW message

[Bob Stephens]

Do you have it on QSK or semi-break-in?   You have to have VOX set to transmit CW but by setting a delay the rig won't go to receive between dits and dahs. 


73 de AF9W
Bob Stephens
Emergency Coordinator
Oro Valley Amateur Radio Club 
af9w at bobandgloria.com
Also contact via 146.62 (-) PL 156.7



On Nov 13, 2012, at 5:53 PM, Jim Klitzing wrote:

> OK, new user here...I'm using the KX3 as a driver for microwave transverters, I can't figure out how to get a recorded CW message to cause the radio to transmit the message unless I use CW VOX, which causes relays in the attached equipment to chatter. When I try to send a message after pressing XMIT, it just goes back to RCV mode. What have I missed?
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html