[Elecraft] Cabling a Yaesu FT 950 to a KPA 500

[Joe Hutchens]

Should read: (Not PA KEY, pin 10 on KPA-500.)
_________

Pins 3 and 8 of the FT-950 are paralleled and tied to ground, pin 5, on 
the KPA-500.  (Not PA KEY, pin 2.)  I looked at the FT-950 schematic and 
it appears pin 8 (FT-950 - TX Inhibit) can be left floating, but I went 
ahead and grounded it anyway as recommended.

See ( http://webpages.charter.net/aj8mh-radio/notebookind8.html ).

Joe Hutchens  ( AJ8MH )
http://webpages.charter.net/aj8mh-radio/


On Thu, Nov 8, 2012 at 12:46 AM, Jack Molinari wrote:

> Am I correct that PA KEY of the KPA 500 is connected to pins 2 and 3 
> of the Linear plug on the rear of the FT 950 in order to ground the 
> circuit?  It is not my intention to use the ALC.
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html