[Elecraft] KDVR3 output level adjust for over the air playback?

[Bruce Beford]

Agreed. Right now, I think all you can do is kick in the attenuator and
reduce RF gain on RX before recording. Not an elegant solution at all. Maybe
with your post, it may percolate up "The List".
73,
Bruce, N1RX

-----Original Message-----
From: Dave [mailto:rocketnj at gmail.com] 
Sent: Monday, May 28, 2012 6:06 PM
To: Bruce Beford
Subject: Re: [Elecraft] KDVR3 output level adjust for over the air playback?

I hope they can address it in firmware. Works well except over-the-air
playbacks on rx are very hot in level

Used it when we ran a special event station a few weeks ago and the dvr was
a must!

73
Dave
wo2x

Sent from my iPhone

On May 28, 2012, at 6:55 AM, "Bruce Beford" <bruce.beford at myfairpoint.net>
wrote:

> Not yet. Many of us are hoping a future firmware update will address that.
> 73,
> Bruce, N1RX
> 
>> Playing with the KDVR3 and understand that tx audio processing has an 
>> effect on DVR recording playing back over the air. With my setup with
>> mild compression and mild EQ'ing the ALC pins on playing a reciording
>> over the air (recording someone and playing back over the air.).
> 
>> Is there a way to pad it down to get the ALC level proper?
> 
>> Thanks
>> Dave
>> wo2x 
> 
> 
> 
> 
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html