[Elecraft] K1 ?

[Bruce Beford]

Dale, 2 band or 4 band? Has another band board been used in this rig? I'd do
a reset to defaults on the MCU (see pg 57 in the K1 manual), and start
again.

GL,
Bruce, N1RX

> Ok, I ran outta ideas, so I am referring this to the group, of super 
> experts here.  A K1, on 30m, narrow vfo, (80mhz) cal op, and b2 chosen
> to be 10.1 however, when selecting the band, the display show 10, then
> 018, then 18.1. That leads one to think it is working on 10.018.1 yet
> it is really on 10.118.1 The tx and rx are correct. It is the display
> flash of 10, then 018 and specifically the 0 that is at issue. Any
> thoughts? Thank you very much and have a Safe Memorial Day.

> --...   ...--
> Dale - WC7S in Wy